Snapmaker Artisan (40W Laser + CNC)
3-in-1 machine: 3D printer, 40W laser engraver/cutter and CNC router.
The Artisan is three machines in one frame: an FDM printer, a 40W module for 3-axis laser cutting/engraving, and 3/4-axis CNC milling, chosen by swapping toolheads. Swapping is the easy part; what gets skipped is the recalibration afterwards, which is how alignment errors happen. Run the calibration sequence every time you change toolheads or bits.
Quick Start
Special training required
The Artisan — laser or CNC — is not covered by the standard induction. Special training is required before you use it; ask an Exco member to arrange it.
Settings
Verified profiles, grouped by module.
3D Printing
| Parameter | Value |
|---|---|
| Nozzle temp | 205-215C |
| Bed temp | 55-60C |
| Speed | standard |
Laser
| Parameter | Value |
|---|---|
| Power | 80-100% |
| Speed | 300-600mm/min |
| Passes | 1 pass for 3-5mm, 2 passes for thicker |
| Air assist | ON |
| Notes | Focus offset: None |
CNC
| Parameter | Value |
|---|---|
| Bit type | 3.175mm Flat End Mill |
| Spindle speed | 12000rpm |
| Depth per pass | 1.0-1.5mm |
| Feed rate | Standard |
| Notes | Clear dust frequently. Use tabs to hold parts in place. |
Troubleshooting
Check the focus height first, then increase passes; a dirty lens loses power, so clean off any residue.
Reduce the depth per pass and check the feed rate. Confirm the material is clamped firmly before restarting.
Repair Guides
Difficulty: Easy · Tools: Lens cloth, isopropyl alcohol
Power off, remove the laser module cover, wipe the lens gently in one direction, and reassemble.
Difficulty: Easy · Tools: 14mm open end wrench, 17mm open end wrench, replacement bit
Power off the machine and loosen the collet nut using the wrenches. Remove the old bit, insert the new one fully into the collet, and tighten the nut securely. Power on and run the toolhead calibration.
Difficulty: Medium · Tools: None (touchscreen only)
Power on the machine and open the calibration menu on the touchscreen. Run platform height calibration, set the work origin for the current toolhead, then run a test boundary check to verify alignment. If you're on the laser, run laser focus calibration as well.
Rules
- Special training is required before using the Artisan (laser or CNC) — ask an Exco member to arrange it.
- Never leave laser or CNC jobs unattended; stay with the machine throughout the task.
- Always use air assist / dust extraction when operating the laser module.
- Wear safety glasses when operating the laser module.
- Secure material fully with clamps before starting any CNC or laser job.
- Ensure the Enclosure door is closed and stays closed during laser operation.
- Keep the emergency stop button within easy reach at all times.
- Report any calibration drift, alignment issues, or unusual noises to exco immediately.
- Clean the laser lens before each use with a lens cloth and IPA.
- Only use authorized bits and tools for CNC operations.
- Log all jobs (material, duration, username) in the workshop registry.
- Only exco can change advanced settings or update firmware.
- Do not use highly reflective materials for laser engraving (except 304 stainless steel and anodized aluminium).